|
Who's Online
There currently are 6027 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This service manual includes drawings, schematics, exploded views, parts list, operating details, and more. Very good scans, very readable. The only thing that made it a 4 star rating was on approximately 4 scans only half of the page was scanned then the other half. I would have preferred the pages to be whole scans.
;
Good manual contains all it takes to update, repair,these types of mixers.Thanks.
;
Great service. Fast response. High quality scan. Good price.
Thank you very much!!!
Oleg S.
;
Well-scanned, complete manual. Contains the information needed for repair and maintenance.
;
It's great to be able to obtain a precious technical information for a real old equipment. The one I got helps me a lot in the area of wiring diagram to repair my antique. PDF gave me clear enough information to find out thr details. Thanks for giving me the oppotunity to be able to access to almost vanished informations.
CDM 900
Abgleichvorschriften / Adjustment Procedures
Abgleichvorschriften
1. Tuner
Messgeräte: Mess-Sender, Wobbelsender, Oszilloskop, Digitalvoltmeter. Servicearbeiten nach Austausch des FM-Tuners: Der FM Tuner ist ein komplett abgeglichener Baustein. Ein Abgleich ist nicht erforderlich.
Abgleich 1. AM-ZF
Vorbereitung Wobbelsender 450kHz über Rahmenantenne in L110 (Ferritantenne) einkoppeln. Oszilloskop an Messpunkt TP4 (IC102 Pin 18). Bandwahl: MW MW, 522kHz Digitalvoltmeter an Messpunkt TP3 (C104). Bandwahl: MW MW 588kHz, MW 1440kHz Mess-Sendersignal über Rahmenantenne in L110 (Ferritantenne) einkoppeln (fmod = 1kHz, m = 30%, Ua nur so gro�, dass das Signal gerade erkennbar ist). Oszilloskop an NF-Ausgang. Bandwahl: MW FM 88MHz Mess-Sendersignal an Antenneneingang, fmod = 19kHz. Oszilloskop an TP5 (linker Kanal) und TP6 (rechter Kanal). Bandwahl: FM
Abgleichvorgang Mit T101 auf Maximum einstellen.
2. MW-Oszillator
Mit T163 bei 522kHz auf 1,7V ± 0,1V einstellen. Prüfen: Bei 1611kHz <10V. Bei 588kHz mit L110 (MW-Antennenspule) auf Maximum einstellen (verschieben). Bei 1440kHz mit TC161 auf Maximum einstellen. Abgleich wechselseitig wiederholen.
3. MW-Vorkreis
4. 19kHz-Filter
Mit T103 linken Kanal und T104 rechten Kanal auf Minimum einstellen.
CN101A
FE101 C104 TC161 IC102
TP3
T163
T101
Pin18/TP4
T104 T103
TP6
TP5
GRUNDIG Service
2-1
|
|
|
> |
|