thanks for this download i got a pioneer bdp-lx70a blu-ray player and it had no manual i search everywhere on the internet and came across owner-manuals.com and i found that it was so easy to find and downloaded from this site if i ever need a manual again this would be the first place that i would come too thanks guys
I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
Text excerpt from page 2 (click to view)
Connecting Putting into Operation Safety and Installation
10 cm
10 cm
20 cm
5x
20 cm
Krieg am Go
lf
! SE
RVICE !
r
! ! ! !
Please avoid:
Damage to the set due to electrical storms by disconnecting the mains and aerial cables. Opening of the set and interventions by incompetent persons. Heat build-up, moisture, and penetration of dust and foreing objects into the set. Obstruction of the ventilation slots.
! ! !
Too little distances inside cabinets. Damage to the mains lead. Scratching and rubbing the picture screen. Clean the picture screen only with a moistened and soft cloth. Use clear and clean water only. Magnetic fields (loudspeaker boxes) near the set.
!
AV3 VGA
L L AUDIO-OUT R
AUDIO IN
R
AV1
AV2
2 EXTERNAL / DEC. - AV 2
L
O U T
AUDIO
L
I N
1 EXTERNAL / EURO - AV 1
R
R
r
Connecting the set to the aerial
Connect the aerial cable with the aerial socket � of the TV set. For TV/video recorder operation, connect as shown in the figure. This highly digitalized TV set assures optimum picture and sound quality. Precondition for this is: A properly working aerial system and an aerial connecting cable with high screen factor (85 dB) between the TV set and the aerial socket or the TV set and the video recorder. Avoid cable loops in the proximity of the TV set.
!
You will find further information on connecting various external units (e.g. SAT receiver, decoder) in the dialog center menu section » Audio-/video connections «.
r r
!
Connecting the TV set with the mains Switching the set on/off
Press the
¢ button on the set. 1, P buttons.
IO
If the LED in the mains button is now illuminated, then the unit is in stand-by mode. Switch the unit on using the remote control by pressing one of the