|
Who's Online
There currently are 5372 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent printing quality. A complete and very useful manual with all details.
;
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
;
Very good quality original datasheet!I like this amazing website!!!!!!
;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
CUC 2030 N � CUC 2080 N
Abgleich / Alignment
3. Bildrohrplatte
Me�geräte: hochohmiges Voltmeter, Zweikanal-Oszilloskop mit Tastkopf 10:1. Servicearbeiten nach Austausch bzw. Reparatur: - Bildröhre, Bildrohrplatte Abgleich 3.1�3.3 - NVM IC82005: Abgleich 1.2�1.8, 2.1, 2.2, 3.1, 3.3
Abgleich 3.1 Wei�wert
Vorbereitung Schwarzwei�-Grautreppe mit Burst einspeisen. Kontrast ({) Maximum. Farbkontrast (i) Mittelwert. Bildschirmhelligkeit (v) Mittelwert. Dialogzeile "WHITE ADJUSTMENT" über " " (DIALOG CENTER) �> "OK" �> SERVICE �> "OK" �> Service Code "8500" aufrufen. Gerät in AV-Stellung. Schwarzbild einspeisen. Bildschirmhelligkeit: Graufläche gerade dunkel. Voltmeter über 220k� an Testpunkt R, G und B. Höchsten Spannungswert ermitteln. Voltmeter (220k�) oder Oszilloskop am Testpunkt mit höchster Spannung
Abgleichvorgang Mit den Tasten "z -" oder "+ g" die Werte für "Grün" bzw. "Blau" so einstellen, da� das Testbild unbunt wird. Kontrolle des Wei�abgleichs mit Kontrast Minimum und Maximum. Dialogzeile "End" mit "with mem." beenden.
3.2 Schirmgitterspannung UG2 mit TDA8375
Am Voltmeter 162,5V±2,5V mit Einstellregler UG2 auf der Bildrohrplatte einstellen. Oder mit OszÃlloskop lt. Skizze.
Schwarzwert
162,5V±2,5V 105-110V
3.3 Schirmgitterspannung UG2 mit TDA8843 oder TDA8844
Dialogzeile "Cut-off align" über " " (DIALOG CENTER) �> "OK" �> SERVICE �> "OK" �> Service Code "8500" aufrufen. Mit "OK" bestätigen.
Mit dem Einstellregler UG2 auf der Bildrohrplatte (oder Fokusblock) den zuerst erscheinenden roten, grünen, blauen oder mischfarbenen Strich gerade gut sichtbar einstellen. Mit "OK" zurück ins Menü.
GRUNDIG Service
9
|
|
|
> |
|